http://ir-heat-plus.com/en/tags/bakery/ Recent content in Bakery on Enhanced Infrared Heating Plus Hugo en-us Mon, 07 Sep 2026 14:53:48 +0800 http://ir-heat-plus.com/en/posts/optimizing-thick-cut-meat-cooking-with-high-power-quartz-infrared-tubes/ Mon, 07 Sep 2026 14:53:48 +0800 http://ir-heat-plus.com/en/posts/optimizing-thick-cut-meat-cooking-with-high-power-quartz-infrared-tubes/ <p><img src="http://ir-heat-plus.com/images/b3ece8bf542b121c0e1440fecbc9594f.png" alt="Optimizing Thick Cut Meat Cooking with High Power Quartz Infrared Tubes"></p> <h1 id="how-to-actually-cook-thick-meats-without-burning-the-outside">How to Actually Cook Thick Meats Without Burning the Outside</h1> <p>If you&rsquo;ve ever tried to cook thick cuts of meat in an industrial bakery oven, you know the struggle. You end up with a piece of meat that&rsquo;s charred black on the outside but still raw in the middle. It&rsquo;s frustrating, and it wastes product. We&rsquo;ve found a way around this using high-power quartz infrared (IR) tubes. Here is the secret: short-wave radiation. Instead of just heating the air around the meat, these tubes push heat deeper into the protein fibers. It doesn&rsquo;t just sit on the surface. The core temperature climbs right along with the exterior, so you get a consistent cook from the edge all the way to the center. But you can&rsquo;t just crank the heat and walk away. Because these tubes pack so much power into a small space, they can be aggressive. To keep things from burning, you&rsquo;ll want to use PID controllers and fast-response thermocouples. Think of it as a closed-loop system that tweaks the power in real-time. It stops that &ldquo;over-sear&rdquo; before it even starts. Now, a word of caution on the hardware. Quartz is great because it handles extreme heat and lets the radiation through perfectly. It&rsquo;s tough in some ways, but it&rsquo;s still glass. If your oven shakes or takes a lot of mechanical hits, don&rsquo;t just toss the tubes in there. You&rsquo;ll need reinforced mounting brackets to keep them from snapping. And keep an eye on your electronics. All that radiant heat doesn&rsquo;t just go into the meat; some of it soaks into the oven chassis. Make sure your insulation and cooling fans can handle the extra load, or you might end up frying your control boards. The best way to set this up? Wire the tubes into a zoned array. This lets you dial in the intensity for different parts of the oven. If you have a few cold spots, you just bump up the power in those specific zones. That way, every single slab of meat coming off the line is cooked exactly the same.</p>